|
Item |
Unit | MD50S6000 | MD100S6000 | MD130S6000 | |||||||||
| Injection Capacity(Option) | T.m | i1.0 | i2.7 | i2.7(0P.) | i4.0 | ||||||||
| Screw Type | Y(0P.) | A | B | Y | A | B | Y | A | B | Y | A | B | |
| Screw Diameter | mm | 18 | 25 | 30 | 30 | 35 | 40 | 30 | 35 | 40 | 35 | 40 | 45 |
| Injection Weight(PS) | g | 20 | 45 | 78 | 78 | 124 | 185 | 78 | 124 | 185 | 124 | 185 | 263 |
| Max. Injection Pressure | MPa | 280 | 200 | 140 | 270 | 200 | 155 | 270 | 200 | 155 | 260 | 200 | 155 |
| Max. Holding Pressure | MPa | 280 | 180 | 125 | 245 | 180 | 135 | 245 | 180 | 135 | 235 | 180 | 140 |
| Max. Injection Speed | mm/s | 350 | 300 | 300 | |||||||||
| Plasticizing Capacity(PS) | kg/h | 9 | 27 | 43 | 43 | 60 | 93 | 43 | 60 | 93 | 60 | 93 | 115 |
| Clamping Force | kN | 500 | 1000 | 1300 | |||||||||
| Distance Between Tie Bars (H x V) | mm | 360x320 | 460x410 | 510x460 | |||||||||
| Mold Opening Stroke | mm | 250 | 350 | 380 | |||||||||
| Mold Height(min./max.) | mm | 160 / 370 | 200 / 450 | 200 / 450 | |||||||||
Notes:
・Specifications are subject to change without notice.
１．Injection Capacity=（Injection pressure）×（Theoretical shot volume）
2．The shot mass(PS) is assumed to be 92% of theoretical shot volume.
3．Max. injection pressure and max. holding pressure may be limited by cycle
time.
4．The maximum injection speed may not reach this value,depending on the
status of load.
5．Plasticizing capacity is assumed by polystyrene.